Rukus Wireless ZoneFlex 7731 Guia do Utilizador descarregar pdf (Página 78)

Configuring the Access Point

Configuring Wireless Settings

NOTE: If you are using a ZoneFlex 7363/7962 AP, go to Configuration > Radio 2.4G

or Configuration > Radio 5G.

2. Click a Wireless # tab to configure. The Configuration > Wireless > Wireless[#]

page appears.

3. Click the Encryption Method menu, then click WPA. The basic set of WPA-specific

encryption options appears on the page.

4. Select 802.1X as the WPA Authentication mode. Additional options appear.

5. Configure the following settings to customize your 802.1X authentication:

• RADIUS NAS-ID: Enter the network ID assigned to your RADIUS server.

• Authentication Server [-Required-]: Enter the information needed to estab-

lish a connection between the Access Point and the RADIUS server.

• Accounting Server [-Optional-]: Enter the information needed to establish

this connection.

6. Click Update Settings to save and apply the changes. A confirmation message

appears at the top of this page.

7. Click Go back to Wireless Configuration to reopen the previous page.

Setting Threshold Options

The following options allow you to fine-tune the “Protection Mode” behavior, set

previously on the Configuration > Wireless > Advanced > Common page. After

activating a Protection Mode, you can open each Wireless tab and customize the

threshold settings, which determine what is put into effect and when.

CAUTION: Do not customize these options unless you are an experienced network

administrator or are under the guidance of an IT/support professional.

To customize Protection Mode (Threshold) settings

1. Go to Configuration > Wireless. The Configuration > Wireless > Common page

appears.

NOTE: If you are using a ZoneFlex 7363/7962 AP, go to Configuration > Radio 2.4G

or Configuration > Radio 5G.

2. Click the tab for the Wireless # (WLAN) that you want to configure. The Configu-

ration > Wireless > Wireless [#] page appears.

3. Look for Threshold Settings, and then click Edit Settings. The Configuration >

Wireless > Advanced > Wireless [#] page appears.

4. Review the options listed in Table 22

, and then make any needed changes.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 119 120

Sem comentários

Rukus Wireless ZoneFlex 7731 Guia do Utilizador Página 78